Comments

inspector wrote on 2/26/2001, 3:49 PM
When you choose the "select drive" option and the drive doesn't show up you can click on the
"advanced button" and add the drive there. This has apparently worked for some people but not in my
case.
If you are unable to add the drive by selecting "atapi mmc compliant" and selet the bus then the
device, find the "forge32.ini" file, and add under [metrics] the line 3307=1. This tells the program to
read the busses differently and should allow you to select the drive and write to it. If this doesn't work
you can reach me at sbergner@mindspring.com.