Chapter Markers too Close?

DavidPJ wrote on 7/27/2003, 11:11 AM
I've imported chapter markers from my Vegas rendered mpeg2 into DVDA 1c. I've created the menus and when I hit Make DVD and prepare, I obtain a warning message for every chapter marker stating that the chapter markers are too close, and they must be at least 1 second apart. All of my chapter markers are much greater than 1 second apart from one another. I have not set any other type of marker.

I've been struggling with this and can't find a solution. Any suggestions? Should I just ignore the warnings?

Comments

vicmilt wrote on 7/27/2003, 12:43 PM
Ignore the warnings and see what happens - what can you lose?
EPsymp wrote on 7/27/2003, 12:44 PM
does it still let you make the dvd..and keep the markers?
BillyBoy wrote on 7/27/2003, 3:07 PM
Anything that has a yellow warning is just that, a WARNING. If there are red flags when you look in optimize, then DVD-A will halt once it hits one would be my guess.

I've seen the same warning, but when entering chapters in DVD-A. Moving a few frames further down solves it.

The $64,000 question is how close ARE you markers?

I can't see a reason to have chapters every few seconds.
BillyBoy wrote on 7/27/2003, 3:08 PM
Anything that has a yellow warning is just that, a WARNING. If there are red flags when you look in optimize, then DVD-A will halt once it hits one would be my guess.

I've seen the same warning, but when entering chapters in DVD-A. Moving a few frames further down ususally solves it.

The $64,000 question is how CLOSE are your markers?

I can't see a reason to have chapters every few seconds.
DavidPJ wrote on 7/27/2003, 3:34 PM
BillyBoy, all markers but one are 1 minute or more apart from each other. the first chapter marker is 9 seconds from the beginning.