Using several video clips (Enable DV scene detection) - imported from a DV Sony DCR-PC110 -gives problem in previewing timeline for som of the clips.
The Project properties is set by using the "Match Media Settings" from one of the clips = "PAL DV Widescreen(720x576; 25,000 fps)" The time line is 24 minutes long with 49 clips.
Importing the clips as well as viewing them in trimmer works fine but after a while when adding more clips some of the clips in the timeline is "Black" i.e only the audio is heard but no video is shown in preview in time line. This applies only to some of the video clips.
Viewing the clips again from media library in trimmer window works fine.
Capturing the same tape (Disable DV scene detection) to one clip works fine.
It's seams better to work with several clips and (Enable DV scene detection)
Any suggestions!
Best regrads
Kjell
The Project properties is set by using the "Match Media Settings" from one of the clips = "PAL DV Widescreen(720x576; 25,000 fps)" The time line is 24 minutes long with 49 clips.
Importing the clips as well as viewing them in trimmer works fine but after a while when adding more clips some of the clips in the timeline is "Black" i.e only the audio is heard but no video is shown in preview in time line. This applies only to some of the video clips.
Viewing the clips again from media library in trimmer window works fine.
Capturing the same tape (Disable DV scene detection) to one clip works fine.
It's seams better to work with several clips and (Enable DV scene detection)
Any suggestions!
Best regrads
Kjell