Comments

jsmiddleton4 wrote on 1/2/2006, 6:27 PM
I'm new to Sony's product. Installed DVD Architect 3, d/l the update, ran the update, and the update wants a new serial number beginning with HE, mine begins with HF. So how do you install the update?
MyST wrote on 1/2/2006, 8:20 PM
If you've registered your software, just go to "FORUM SETTINGS-My Software" just to the upper right of this thread.
You'll see your serial number for the different software you've registered. Then you can just copy-paste the serial number when prompted.

Mario
jsmiddleton4 wrote on 1/3/2006, 5:10 AM
I have the serial numbers for the software. The serial numbers are on the front page of my manuals. The serial number I have does not work for the 3.0c update. Mine begins with an HF. 3.0c is asking for something that begins with an HE.

Jim
jsmiddleton4 wrote on 1/3/2006, 5:11 AM
I also can't seem to get the Capture piece registered either. I have no serial number for it in the box.
jsmiddleton4 wrote on 1/3/2006, 5:27 AM
Registered when I installed the software. Sent to the forums settings, my software, d/l the patches listed there. They did nothing. No install/update. They simply didn't run.

Just what product does the 3.0c patch/update actually apply to?
Chienworks wrote on 1/3/2006, 9:27 AM
jsmiddleton4, by any chance are you using the "Studio" version of Vegas and DVD Architect? This 3.0c update is only for the full version, not the Studio version.
jsmiddleton4 wrote on 1/3/2006, 10:07 AM
Figured that out. The update link on My Software link is not the 3.0c version. The download page is confusing. However the My Software page takes care of it.

Jim