I keep getting the following error after trying to burn a prepared DVD file. This occurs after about 3 mins of burn time.
pop up message under title:
CD/DVD Operation
Details
'SFMMCX'-(17)
''-(0)
-'MATSHITA DVD-RAM UJ-850S 1.60'-(0)
Module sfmmcx.cpp Line 2240
A hardware error occurred.
Unknown Additional Sense 03 00
Status: 00020202
Command: 2a 00 00 00 05 e0 00 00 20 00
Sense: 04 03 00
Info: 00 00 02 f0
Specific: 00 00 00
Extra: 00 00 00 00 00 00 e0 8d b2 84
From when I first purchased the sw I was able to burn DVDs without a problem.
I have reinstalled the sw now to version 4.5d. Also follwed the full Clean uninstall instructions.
I conducted a full hardware test and the report showed it is functioning ok.
I have tried to burn an old project, that did burned ok previously. This was not successful.
I should note that the burn process does start, however, after 3+ minutes it terminates/fails. During this time the sw is trying to estimate the time for completion but is unable to do so and hence the estimated time continues to climb up to approx 1hr 20min at point of failure.
As I mentioned, the burn process starts. So there is information on the DVD, this starts up in run mode and I can usually view the main DVD menu. But that's it... when you select a sub-menu/slide show it fails.
pop up message under title:
CD/DVD Operation
Details
'SFMMCX'-(17)
''-(0)
-'MATSHITA DVD-RAM UJ-850S 1.60'-(0)
Module sfmmcx.cpp Line 2240
A hardware error occurred.
Unknown Additional Sense 03 00
Status: 00020202
Command: 2a 00 00 00 05 e0 00 00 20 00
Sense: 04 03 00
Info: 00 00 02 f0
Specific: 00 00 00
Extra: 00 00 00 00 00 00 e0 8d b2 84
From when I first purchased the sw I was able to burn DVDs without a problem.
I have reinstalled the sw now to version 4.5d. Also follwed the full Clean uninstall instructions.
I conducted a full hardware test and the report showed it is functioning ok.
I have tried to burn an old project, that did burned ok previously. This was not successful.
I should note that the burn process does start, however, after 3+ minutes it terminates/fails. During this time the sw is trying to estimate the time for completion but is unable to do so and hence the estimated time continues to climb up to approx 1hr 20min at point of failure.
As I mentioned, the burn process starts. So there is information on the DVD, this starts up in run mode and I can usually view the main DVD menu. But that's it... when you select a sub-menu/slide show it fails.