DVDAS3 In out points

Nel. wrote on 10/29/2005, 12:45 AM
I created a scene selection and want each scene to return to the scene selection menu after playing....
The first marker reads: 1 Chapter.... 2 Titles ....3 JG ...4 Ac...
I want the first scene reads 1 Titles....then 2 JG... 3 Ac...
I read the instructions... but I keep on erring somewhere...BROKEN LINK in red appears.....I DON"T WANT TO SEE 1 Chapter which refers to the video project....
I can create the 2 Titles (Even though I want it to be the first marker), but when I create the 3 JG I see a grey mask on about the whole video and when I push that mask and use the in and out points or drag the yellow arrow...all the markers numbering is changed . I tried to ignore that... but in the preview now the 2nd scene takes over... and the first one is wiped out....

I wish I could see a picture of a Project Overview and see how is it supposed to look.... with the scene selection... and the media properties...
Can somebody help me?

Comments

PeterWright wrote on 10/29/2005, 5:54 PM
Firstly I don't know how the Studio version varies from DVDA3, but with the full program ....

To play a single chapter then return to the menu, don't use Scene Selection.
Instead create a submenu (if required), then lift the same movie to the menu again. Double click on it to open and set In and Out points by dragging. Repeat this for each chapter you want to play this way.
Even though you havve added the same movie several times, DVDA will know that it's the same movie and not "double up".
Nel. wrote on 10/30/2005, 12:14 AM
Thank you for your suggestion... yes it works... but it is so time consuming compare to the older version.... I posted my question into MovieStudio and wait to see if somebody has a faster or easier way....Thanks again, I appreciated it.
Nel. wrote on 10/30/2005, 3:14 PM
No other easier way from Movie Studio side....
But I succeded .... "scene selection" with return to the menu, music and all.... Thanks again for the support....