Editing not taking effect

kipphut wrote on 10/17/2005, 6:41 PM

hey guys. here is what I just came across. When I edit a burned saved product no changes take place. I have to rebuild the whole project again?? How can I edit so my changes take place.

Thanks

Comments

PeterWright wrote on 10/17/2005, 10:26 PM

In the Make DVD sequence make sure you use "Prepare current project" rather than "Use previously prepared project".

The latter will re-use the previous version

kipphut wrote on 10/18/2005, 7:06 AM

I looked everywhere in the program on where to change this. Can't find that setting anywhere???

Thanks Again

bStro wrote on 10/18/2005, 7:31 AM

Start by telling us what version of DVD Architect you're using. There's DVD Architect 1.0, DVD Architect 2.0, DVD Architect 3.0, DVD Architect Studio 2.0, and DVD Architect Studio 3.0.

Rob

johnmeyer wrote on 10/18/2005, 7:46 AM

You must be using Studio. In DVD Architect, you simply click on Make DVD and then you get the choices.

kipphut wrote on 10/18/2005, 8:22 AM

DVD Architect 3.0

OK I found this:

"Prepare current project" rather than "Use previously prepared project".

Everytime I edit and tell it to prepare the current project I get an error when reording. It says it can't determain the problem.

But When i recreate the same project it burns fine. Any reason why??

Thank Guys.

Steve Mann wrote on 10/18/2005, 12:42 PM

The first time that you 'prepare' the DVD, you have the option to browse for a location to save the work. The next time you hit 'prepare' for that project, the "Prepare to folder" will be the same, and the Smart Prepare is defaulted on.

If you use the temp folder for the initial prepare, you won't see the Smart Prepare option on subsequent 'prepares'.

Steve