"Fade Offset"...how do you do it?

edna6284 wrote on 8/25/2001, 9:21 AM

Last night I stumbled across creating a crossfade offset, where one half of the crossfade actually ended earlier than the first! I'm not sure how I did this, but can someone tell me how to repeat it? I'm using VV2....

Thx
D

Comments

FadeToBlack wrote on 8/25/2001, 5:21 PM

edna6284 wrote on 8/25/2001, 8:03 PM

Thanks GG, I do that a lot....what I'm interested in finding out here however, is how to control Crossfade Offset. It exists, yet there's nothing in the manual that mentions it (that I can find, that is)

Thanks,
D

FadeToBlack wrote on 8/25/2001, 8:27 PM

edna6284 wrote on 8/25/2001, 10:29 PM

That's what my question is...I did it once, but I can't repeat it. Hopefully someone in the know will help us out....

stumacQ wrote on 8/26/2001, 4:03 PM

Hmm ...

I don't know if you're talking about the snap offset, but ... you can change that by dragging the little white triangle in the bottom left corner of every event.

Hope that helps.

-=(stu.macQ)=-

edna6284 wrote on 8/27/2001, 12:26 PM

No, thanks, it's a way you can make one part of a crossfade end earlier than another. Not fade type or anything like that....