Finishing a blu ray

beanboy39 wrote on 2/2/2012, 8:10 AM

I am unable to select Finish to burn my blu ray. I burned one the other night, but found video that skipped, so I rendered the whole project again, now when I go to burn, I can't select finish. It is there but I am unable to select it. Do I have to render my project again?

Comments

Steve Grisetti wrote on 2/2/2012, 8:38 AM

No. As a matter of fact, you can use the ISO file that was Prepared the other day to burn a new disc. (Skipping is not a software issue. It usually means you had a bad burn or you used a bad disc for your burn. Memorex discs, in particular, are famous for failing about as often as they work.)

Check to ensure that the disc you have in the drive is blank. (If it's an RW, make sure it's been completely erased or reformatted.) Or try another disc.

beanboy39 wrote on 2/2/2012, 8:52 AM

I tried to use the one I rendered the other day, and again it would not let me select finish. I'm sure I had a blank disk, but I will double check this evening. Thanks again for the help.