Help printing to tape ASAP

randyvild2 wrote on 3/4/2004, 1:22 PM

OKay 15 minute project done. I loop region then set up print to tape and have camera set up. Everything worked however I had camera on VHS mode and should have had CAMERA mode. So I reset and video this time does not have to render everything however on step 4 of 4 I get this error:

error 0x8007001f message missing

Any clues what to do?
This project is due today an hour ago.

Comments

randyvild2 wrote on 3/4/2004, 8:07 PM

No answers hmmmm.....
I changed locations to the prerender destination folder, I rebooted and then had to go through the pre render/print to tape 3 hour/ 20 steps process and on step 20 of course you guesed it this error:
0x8007001f

Sony should have a web page with a list of all the errors and their meanings.

riredale wrote on 3/5/2004, 9:05 AM

I have absolutely no idea. I also have no knowledge of these occasional "Print to tape" threads. I can mention, however, that I never try to go to tape directly from my edited project. I instead have Vegas build a finished avi, and THEN go to tape from that clean avi.

Good luck.

jetdv wrote on 3/5/2004, 9:16 AM

The camera should be in VTR mode IF you want to record from the firewire stream (sounds like you had it right the FIRST time). In camera mode, it should record through the lens.

There *may* me a menu option on the camera in which you have to specify whether the firewire is being used for input or output.

randyvild2 wrote on 3/5/2004, 3:49 PM

Riredale,
You are a genius! I was having problems with my E drive external drive which this project is on because it was reading from over 50 gigs of soccer clips and my stupid firewire would disconnect.
So I rendered a clean avi. and broght it over in a new Veg project on my C drive. Whamm no error and the result was a beautiful clean mini DV video!

Thank you...I love this fourm!

Randini