Folks
Just started looking at LUTs for the first time and have installed the Technicolor cinestyle profile to a couple of my Canon DSLRs and the Visioncolor plugin on my v14 install.
I can browse and apply .ofx to a clip but it doesn't appear to do anything. What am I doing wrong / missing?
TIA
For the Visioncolor plugin you have to load a LUT with one of the extensions 3DL, CUBE, MGH, HDL, CCC, CC, CSP or CUB into the plugin and then you can see the result.
Each load can be saved as a preset.
For the Visioncolor plugin you have to load a LUT with one of the extensions 3DL, CUBE, MGH, HDL, CCC, CC, CSP or CUB into the plugin and then you can see the result.
Each load can be saved as a preset.
Thanks. I'm sure this is glaringly obvious to most people but my next question then is, where do I go to find these files?
try this. gives complete instructions. interesting, used it on a project and got good results...
try this. gives complete instructions. interesting, used it on a project and got good results...
Thanks Dlion looks like some RTFM for me 😉
mostly otj learning. all i read was the one-page instructions for vegas on the site.
you use one of their input filters first, one of their output filters last, and whatever cc you use in between. i used a hitfilm plug with magic bullet looks in between, and color match last in the chain.
i was able to to get an m2t clip and a wmv (original m2t lost) to look reasonably the same by tweaking elements and lagarist filters.