Loop Region Hot Keys

Byron K wrote on 9/20/2009, 1:54 PM

Would anyone happen to know what are the hot key functions to snap the beginning and end of the loop region to where my cursor is w/out zooming all the way out and moving the loop points.

The manual says: Shift + Q, but that doesn't reset the loop point to where my cursor is.

When my whole time lines is selected as the loop region, I constantly have to zoom out to grab the beginning and end loop points to reposition them

Thanks,
Byron

Comments

rs170a wrote on 9/20/2009, 3:08 PM

Home key:
Go to beginning of time selection or viewable area (if no time selection)

End key:
Go to end of time selection or viewable area (if no time selection)

Mike

richard-amirault wrote on 9/20/2009, 4:18 PM

That's not what he was asking...

To set the begining of the loop region at the current cursor position:
hit the "I" (in-point) key.

To set the end of the loop region hit the "O" key (out-point)

Byron K wrote on 9/21/2009, 11:20 AM

YES! i/o "in - out" keys are what I needed.

I was referring to them as "begin - end" and "start - end" loop points.

...and there it is 2nd to the last entry on in the Keyboard Shortcut Reference, Cursor Placement Section, Set In and Out points.

Thanks for your assistance!