Negative 3D space

ezway wrote on 3/22/2005, 6:31 PM

Hellom
Thank you in advance for taking time to help.
I have a still photo in track 1 with bezier
mask set to negative on to sections (objects).
In track 2 I have a motion loop of a film sequence.
In track 3 I have another loop of a film sequence.

Quesion is how may I get track 2 to show in section 1 and track 3 to show in section 2?

Thank you,
marty

Comments

Chienworks wrote on 3/22/2005, 6:50 PM

Consider using Track Motion to shrink and move the background clips so that they fit in the holes and don't overlap each others holes.

ezway wrote on 3/22/2005, 7:29 PM

Yes and thank you, Problem is I am getting two tracks in the same object.
Best wishes,
marty

Chienworks wrote on 3/22/2005, 7:33 PM

This is not a problem. Track motion allows you to move the frame of a track off to one side. When you move track 2 far enough to one side it won't be behind the hole for track 3 anymore, and therefore won't be overlapping it.

ezway wrote on 3/22/2005, 7:41 PM

Ok I will try now and post in a few minutes,
Thank you so very much.
Marty

ezway wrote on 3/22/2005, 7:58 PM

Ok I used track motion to move the underlying track into a space where it shows only through one mask.
Is there another way, by size or parent child tracks?

Thank you,
Marty

Chienworks wrote on 3/22/2005, 8:16 PM

There are many ways. You could use Pan/Crop instead of Track Motion. You could add a new track between 1 and 2 and place a mask on it to hide part of one background from the other side. I'm sure there are a few others too, but these are probably the most straight forward.

ezway wrote on 3/22/2005, 9:21 PM

Thank you, very much,
I will try to mask out a portion of track 2 and 3 and see if I can get better results.
Thanks,
Marty