New and need help NEWBLUE FX

bholder78 wrote on 1/22/2008, 9:06 AM

i am trying to get NewblueFX and I am having a hard time figureing it out. Are there any manuals or Help site I can go to for help? I am a completely new at this and cannot figure this out. Thanks For the help.

Comments

Himanshu wrote on 1/22/2008, 10:55 AM

Your message is too vague to give a specific answer. Using NewBlue FX is no different than using any Sony FX. So questions:

1. Are you trying to use a transition, or a video fx?

2. Are you familiar with using any Sony transition or fx? If the answer is no, start by going through the "Show Me How" tutorials. They are very good! Also look at Sony's web site for some Vegas training videos. Here's a link for some third party Vegas Movie Studio Tutorials

3. If you still continue to have problems. Please post a very specific question about a specific transition or fx.

Welcome to the world of SVMS and good luck!

[EDIT: add Sony's Vegas training URL]

Ivan Lietaert wrote on 1/22/2008, 10:22 PM

In order to install Newblue FX, you must run the file vmspe8_videofx.exe. During the installation, you must fill in your licence number, which is in the email received after placing the order.

RandyS wrote on 1/23/2008, 6:35 AM

I just installed these too and wasn't sure where they were in moviestudio.

Once installed properly you'll find them in the Video FX tab and then you'll probablly have to scroll down to see them since they start with "N" and the list is alpha sorted.