i've read everything on the forum (especially that, most informatively written by jerry), and am just seeking an answer to a simple question:
how well does material from the tm700 cut with the z5 (in pal).
i ask cause my old v1 has a back-focus problem that might prove more costly to repair than it's worth.
the basic use for the tm700 would be as a wide, cutaway, two shot (on legs) during interviews. my z5 will be doing the cu's. (all under controlled lighting)
people have suggested the sony cx 500 / 700, but they seem to be single sensor (?), a bit more expensive and automatic?
any thoughts most welcome.
how well does material from the tm700 cut with the z5 (in pal).
i ask cause my old v1 has a back-focus problem that might prove more costly to repair than it's worth.
the basic use for the tm700 would be as a wide, cutaway, two shot (on legs) during interviews. my z5 will be doing the cu's. (all under controlled lighting)
people have suggested the sony cx 500 / 700, but they seem to be single sensor (?), a bit more expensive and automatic?
any thoughts most welcome.