Quick DVD Burn

Jack McCann wrote on 10/18/2005, 7:32 AM

I'm using DVD Architect Studio.
How can I do a quick MPEG 2 + Audio Burn on DVD+R DL media without a lot of set-up of this and set-up of that? When I tried to burn the file last night I got a message that the menu was over the max of 1 G. I don''t even want or need the menu. How I can avoid or short cut this and just burn the DVD?
Thank you!
Jack

Comments

ScottW wrote on 10/18/2005, 11:56 AM

File, New... single movie

It soulds like what you did was set your video to be a motion menu, which would have put you over the limit.

Jack McCann wrote on 10/18/2005, 12:51 PM

How did I do that?
Thank you for the reply Scott.
Jack

ScottW wrote on 10/18/2005, 3:22 PM

If I had to guess, I would guess that you selected the video button on the properties section or your new project and then selected your video, which would have told DVDA to use that video file for your menu.

Normally with a menu, you just drag the video file from the explorer window onto the menu.

--Scott

Jack McCann wrote on 10/18/2005, 3:58 PM

Scott,
I'll dump this project and start over. I'm an Old Dog learning new tricks!
Thank you again!
Jack