Renderig to PRINT TO TAPE

Joni wrote on 4/16/2003, 8:02 AM

When rendering a project to print it to tape, what is the best type of render to use? (codec, quality etc) - I use DV PAL.

thanks

djoni

Comments

Chienworks wrote on 4/16/2003, 8:12 AM

If you're printing to DV tape, then you must use the DV .avi codec. If you're in PAL land, then you should use PAL. The only custom change you can make is the Video rendering quality. It defaults to Good but you can change it to Best if you wish. However, this usually slows the render down without noticeably improving the quality much.

Joni wrote on 4/16/2003, 2:52 PM

Chienworks, thanks once again. You've been very pancient with my amature questions :-)

so, If I got you right, chosing GOOD is professionaly accepted. I am right?

thanks

joao