reverb render

adowrx wrote on 12/23/2003, 9:03 PM

Add reverb to a subgroup and or master mix bus. When playing back Vegas VV3 project reverb tail is always present. After rendering, to stereo wav file, reverb tail at end of file is cut short. I always have to go back to original VV3 file to insert a clip with silence at the end of the project that covers the length of the reverb or delay tails. Does Vegas 4 still render in this manner? I figure that plugs should render in their entirety, including reverb or delay plug tails. The workaround is simple, but.........

-jb

Comments

pwppch wrote on 12/24/2003, 1:05 PM

There is no way to know how long the tail is going to be. Your work around is the current solution. Perhaps we could add a "render x amount of time" after end to cover reverb tails.

Peter

drbam wrote on 12/24/2003, 2:18 PM

You could select a loop region for entire project that extends enough to include the tails and then check the box "render loop region only" when the render dialog box comes up. Theoretically that should do it and would be easier than inserting the tail after the fact.

drbam

adowrx wrote on 12/31/2003, 11:55 AM

Thanks for the input! Looking fwd to V5!

-jb