Ok,
has anyoen had this problem ever. I have a MCU & XT Extender and I plugged them into new MOTU Midi Express XT USB in I/O ports 1 and 2 Now, both Acid and vegas find the MCU but are having big problems finding the XT. Now if I double click on scan under the Mackie Control Configure page it finds the XT but leaves the MCU off Line. However where it selects the XT it makes the Midi in correct on Port 2 but then makes the out on port one so it ends up duplicating the settings on the MCU so they both end up working as one unit. Now it still only reads 1-8 in the channels. On the MOTU it reads 2 on the XT going to port 1 on the out. And they are grayed out so I can't change them Now I tested this with an Audigy card with 2 ports on another computer and it detected both the MCU and XT perfectly as soon as I installed the MOTU on that computer to test it did the same thing, so the problem lies in the MOTU confguration. Please advise thank you!
Joe
has anyoen had this problem ever. I have a MCU & XT Extender and I plugged them into new MOTU Midi Express XT USB in I/O ports 1 and 2 Now, both Acid and vegas find the MCU but are having big problems finding the XT. Now if I double click on scan under the Mackie Control Configure page it finds the XT but leaves the MCU off Line. However where it selects the XT it makes the Midi in correct on Port 2 but then makes the out on port one so it ends up duplicating the settings on the MCU so they both end up working as one unit. Now it still only reads 1-8 in the channels. On the MOTU it reads 2 on the XT going to port 1 on the out. And they are grayed out so I can't change them Now I tested this with an Audigy card with 2 ports on another computer and it detected both the MCU and XT perfectly as soon as I installed the MOTU on that computer to test it did the same thing, so the problem lies in the MOTU confguration. Please advise thank you!
Joe