Since I installed Win98 CD Arch says:"The drive is busy processing a command"

JanB wrote on 5/26/2001, 6:57 AM

Hi! I'm here because I have a problem and need your help. I usually works with win95 but recently I have installed win98 because I need it in order to use some new applications.CD Arch. works very good untill then.The only change in my PC is that: win95 to win98 and since then CD Arch. always do the same:it writes lead in and when tries writeing tracks a message appears saying:"The drive is busy processing a command".The problem is not my CD-R because I can burn all types of CD's with any other application without problems.My CD-R is an IDE Yamaha 8424.I have done a lot of tests and I have discovered that when I use a small wave (less than 2MB) and I do only two marks (in order to write a 2 tracks CD) CD Arch. works perfectly.
Why I have this problem?What can I do? I NEED HELP.Thanx!

Comments

JanB wrote on 5/29/2001, 1:08 PM

Hi again! Nobody answers me, and I have found the solution. I reply myself because of someone has the same problem I have. I have made lots of test since I posted my S.O.S. and there is a solution very easy: install one,two,three... n-times CD Arch. untill it works ok. There isn't any other secret. I just can say that I have seen this problem only when the O.S. is Win98. Nothing more, friends. Thanxx for everything.