As usual, thanks for your help, Charles.

Charles de Montebello wrote:
>>well, no, it actually looks lit they all go to that aux but in fact
>>they all just switch to the control for that aux. If you switch
back
>>to pan, they all go back to pan. You don't have to apply any level
to
>>the other tracks for that aux... Make sense? If you had an
assignable
>>FX, you'd see the same thing when you pulled down the control for
>>that FX. You could then go to other tracks in the project an assign
>>the global volume for that FX for each track. Don't worry - it's
not
>>what you think. You just have to get used to it.
>>
>>Good luck. Hope that helps.
>>
>>Thomas Kay wrote:
>>>>Thanks again, Charles. But the problem now seems to be that if I
>>>>choose an aux for one track, all of the other tracks go to that
aux
>>>>as well. I clearly will want to use different aux's for different
>>>>tracks. Could this be a bug? I only have 1.0a.
>>>>
>>>>Charles de Montebello wrote:
>>>>>>Hi Thomas -
>>>>>>I'm not anywhere near Veags but I'll try to do it from
memory...
>>>>Once
>>>>>>you've set up how many busses your project has (alt-enter to
get
>>to
>>>>>>the Project Poperties pages - then go to audio and choose 2 or
>>more
>>>>>>busses), you will see that each track now has a drop-down menu
>>>>where
>>>>>>the pan level is. This happens as soon as you add FX or have
more
>>>>>>than one buss. Click on it and you will see Aux1... up to the
>>>>number
>>>>>>of busses you have (or something like that). So, those are
>>your "FX
>>>>>>sends" out to other hardware. You can route those Aux outs to a
>>>>>>different buss and then route that buss to the MPX1 or
whatever.
>>>>Use
>>>>>>the pre volume option (right-click on the same place as the
drop-
>>>>down
>>>>>>menu) and then add envelopes to controll send levels and
timing...
>>>>>>
>>>>>>Good luck. I hope that helps.
>>>>>>
>>>>>>Thomas Kay wrote:
>>>>>>>>I only pray that I'm a good enough songwriter, because I
>>>>>>>>can't figure this out. What I'm trying to do is to send the
>>>>>>>>signal out of Vegas- via my RME Hammerfall 9652 + converter-
>>>>>>>>to my Lexicon MPX 1.
>>>>>>>>
>>>>>>>>This was a previous post that I am having trouble
>>>>>>>>disseminating.
>>>>>>>>
>>>>>>>>"You can add a Main bus and use it as an AUX bus/send.
>>>>>>>>Example...
>>>>>>>>
>>>>>>>>- Set up you main outs to have 2 main busses. Each should
>>>>>>>>be assigned to a different harware output."
>>>>>>>>
>>>>>>>>How can I set my main outs to two outputs?
>>>>>>>>
>>>>>>>>- Assign all tracks main outputs to Bus A
>>>>>>>>
>>>>>>>>I get that.
>>>>>>>>
>>>>>>>>- Assign the tracks you want to montior using the multi
>>>>>>>>selector(pan) and assign them to Aux B.
>>>>>>>>
>>>>>>>>Can't figure that out.
>>>>>>>>
>>>>>>>>- You can set the Aux B send to pre or post fader (right
>>>>>>>>click on the fader when set to Aux B.)
>>>>>>>>- Set the send levels for the monitor mix for each track
>>>>>>>>- Set the overall level for the monitor mix in the Bus B
>>>>>>>>master fader.
>>>>>>>>
>>>>>>>>I'm sorry, but I can't understand it. As plain as it might
>>>>>>>>seem, could someone try and reword it for a simpleton.
>>>>>>>>
>>>>>>>>Thanks, Thomas.
>>>>>>>>