Vidcap save project problem

JJKizak wrote on 5/8/2005, 9:15 AM

With V6.0a I did not save a half captured completed project after capturing in vidcap and when trying to capture again it caused windows malfunction (end now program not responding) After saving the initial project then everything was kool. During the problem it would capture but would not put the clip in the media pool. It would also say that the application detected an incomplete project and would you like to restore it? I kept saying no. It was a project interrupted by the second freeze up of the application. Everything working ok now even with Nero Capture and Moviemaker capture. Device control on and scene detect off.

JJK

Comments

Jameson_Prod wrote on 5/8/2005, 6:24 PM

If you will search, you will find lots of post dealing with capture problems and Vegas 6. Most all seem to come from disabling Media Manager.

Make sure it is enabled....then give it a try. I think you will find everything works fine UNTIL you turn off Media Manager.

Good luck.

JJKizak wrote on 5/9/2005, 9:20 AM

Thanks. I have it turned on and everything works. The more I get into this 6.0a the more I like it.

JJK