Hello All,
It appears that CD Architect is writing the tracks I set
incorrectly. It's starange because at the end of the burn,
the message comes up that says "operation completed without
errors, no errors detected during write process" but then
when I play the CD on my stand-alone home cd player (or any
of my computer drives at home or work, boombox, car, etc)
what should be one track is cut up into multiple tracks, all
the remaining tracks don't start where they are supposed to,
etc. Has anyone ever had this problem? Any suggestions?
Fwiw, my sytem contains:
Win98
Pentium III/500 MHz
128 Meg Ram
18 gig hard drive (IDE)
Adaptec 2930 SCSI Card
Plextor "UltaraPlez32" PX-32TS CD ROM (SCSI)
Smart & Friendly "CD SpeedWriter" CD-R4012 (SCSI)
ps. I had all the same software and hardware (except the
2930 scsi card) in my old system and everything worked fine.
Old system was Win98, 233 MHz, 32 meg RAM, 4 gig IDE hard
drive. Adaptec 1505 scsi card (came with the CD-R4012). I
had to upgrade to the 2930 scsi card because I had no ISA
slots in the new computer (which I inherited).
ps. I did the vcache tweak, power management, turned off all
background utilities, etc, etc...
I really hope I can get this problem solved because I really
like CD Architect and want to continue using it.
pps. Did I mention that CDRWin & EZCD Creator are working
fine in the new system?
It appears that CD Architect is writing the tracks I set
incorrectly. It's starange because at the end of the burn,
the message comes up that says "operation completed without
errors, no errors detected during write process" but then
when I play the CD on my stand-alone home cd player (or any
of my computer drives at home or work, boombox, car, etc)
what should be one track is cut up into multiple tracks, all
the remaining tracks don't start where they are supposed to,
etc. Has anyone ever had this problem? Any suggestions?
Fwiw, my sytem contains:
Win98
Pentium III/500 MHz
128 Meg Ram
18 gig hard drive (IDE)
Adaptec 2930 SCSI Card
Plextor "UltaraPlez32" PX-32TS CD ROM (SCSI)
Smart & Friendly "CD SpeedWriter" CD-R4012 (SCSI)
ps. I had all the same software and hardware (except the
2930 scsi card) in my old system and everything worked fine.
Old system was Win98, 233 MHz, 32 meg RAM, 4 gig IDE hard
drive. Adaptec 1505 scsi card (came with the CD-R4012). I
had to upgrade to the 2930 scsi card because I had no ISA
slots in the new computer (which I inherited).
ps. I did the vcache tweak, power management, turned off all
background utilities, etc, etc...
I really hope I can get this problem solved because I really
like CD Architect and want to continue using it.
pps. Did I mention that CDRWin & EZCD Creator are working
fine in the new system?