Bezier mask mode disabled (V5)

Randy Brown wrote on 4/21/2005, 12:33 PM

Hey all,
I have never had a use for bezier masks but I'm looking for something constructive to do while things are slow.
I traced my image and was going to cut it out but the mode is disabled and greyed out and I can't change it to positive or negative...can you tell me what I'm doing wrong? Alsocan you point me to a good tut?
TIA,
Randy

Comments

Jimmy_W wrote on 4/21/2005, 1:36 PM

Randy at a glance sounds like when your creating your mast that you have not completed your anchor points back to the first anchor point. It will stay greyed out until you complete mast . the best way for me to desribe this is to create a circle, create anchors in a circle until reach your first anchor point and click the first anchor point then vegas will create a outline around the mast. I hope this is what your after.
Jimmy

Randy Brown wrote on 4/21/2005, 1:54 PM

That was it Jimmy, somehow I had not "connected all the dots". Cool, now can you tell me where a good tut on this is....or do I know everything there is to know now?
Thanks Jimmy,
Randy

Jimmy_W wrote on 4/21/2005, 2:08 PM

Randy, what gave me jump start on this was Gary Kleiner's vegas 5 companion
lots of good stuff even for the advanced user.

Jimmy

www.vegastrainingandtools.com

Randy Brown wrote on 4/21/2005, 3:29 PM

Thanks Jimmy I'll check into it.
Randy