Error Message When Opening CD Architect belltunes wrote on 4/16/2005, 1:11 PM I installed CD Architect and when opening the program receive the following error message: "An error occurred starting CD Architect. The reason for the error could not be determined" Other then this initial error message the program seems to be working as expected. Any ideas? Thanks in advance. GH Back to post
Comments rdolmat wrote on 12/7/2005, 7:38 AM me too. RichK wrote on 12/28/2005, 6:58 AM Same here too. Why so long in getting a reply? Geoff_Wood wrote on 12/28/2005, 1:43 PM Did you try re-installing ? Did you report the fault through the proper channels ? geoff ForumAdmin wrote on 1/3/2006, 8:49 PM Have you disabled Windows Terminal Services in WinXP? Check out this Knowledge Base article: Launching the software reports 'An error occured starting *PROGRAMNAME*. The reason for the error could not be determined' RichK wrote on 1/8/2006, 7:56 AM ForumAdmin, Bingo! That did the trick. Switched from disabled to manual. Hit start....problem solved. Thanks for the quick comeback. Rich K 1