maxumum pan and zoom

tkalvey wrote on 2/14/2006, 8:02 AM

How can I extend what appears to be the maximum pan/zoom. When I zoom out, I can only zoom out to a certain "length".

In my current situation, I am zooming out on company logos. My current project ends with a page full of logos. My inability to zoom out further than what I'm locked into limits where I can place the logos.

Comments

JohnnyRoy wrote on 2/14/2006, 8:11 AM

There is a limit to the zoom but make sure you have reached it. In the Pan/Crop dialog, open the Workspace properties and set the Zoom (%) to the smallest value 12.5. Then expand your frame as large as it will go. That’s your maximum zoom out with Pan/Crop.

To zoom further, use Tack Motion. This will allow you to make the logo so small that you can’t see it anymore. (that should be small enough) ;-) I would imagine that Track Motion would be easier to use if you are building a page full of logos (just put one logo on each track and position and size it any way you want)

~jr

johnmeyer wrote on 2/14/2006, 9:20 AM

Yep, track motion.

tkalvey wrote on 2/14/2006, 10:08 AM

learned something new.....

thanks alot!!!!