no loop in scene selection??

gmes29 wrote on 9/12/2006, 1:18 AM

as mentioned in another post, i added an audio file to the main menu and looped it for 30 seconds. here, the music restarts after 30 seconds where the looped position resets to 0. however when i do the same to a scene selection menu, the music doesn't loop - it just stops after 30 seconds where the looped position does not reset. all properties are the same as they are in the main menu (except for the audio file) but it just doesn't work. is there something about scene selections that prevent this from working?? it's just another menu so you'd think it would..

Comments

Chienworks wrote on 9/12/2006, 3:39 AM

You have to set the end action for the menu to loop. By default the end action is hold, which doesn't loop.

rustier wrote on 9/12/2006, 4:13 AM

is the menu end action set to loop? sounds like it is set to "hold"

I think you can set a loop point without setting a loop end action - which is a little confusing

hope that helps

LOL good morning Kelly!

gmes29 wrote on 9/12/2006, 5:50 AM

that's probably it.. thanx guys..
apparently the default for a main menu is already loop since i'm pretty sure i didn't have to change it there..