Comments

Jack S wrote on 8/22/2020, 5:40 PM

@william-p I've never done it but try this and see if it solves your problem.

 

Teagan wrote on 8/23/2020, 4:12 PM

Do you have it set to loop or just play once? The default is 30 seconds for length and then it stops.

Go to End Action and then Command > Loop. It will play the menu and then loop over and over from there.

Also, check the length of your menu timeline compared to the length in the picture @Jack S posted.

Jack S wrote on 8/26/2020, 9:28 AM

@william-p It'd be nice if you could report back and tell us if you've been successful, and if you have, what was wrong.🙂

william-p wrote on 8/26/2020, 10:56 AM

I finally gained success, but not to the degree I had hoped. I had to develop the menu by constructing a five-second musical interlude before the navigation tools appeared. I have not been able to start the music at the beginning of the menu and to get it to play the complete length of the song I am using - which is two minutes, forty seconds in length. I am probably missing some simple part of the instructions. Maybe that tells me something!!?!?

Jack S wrote on 8/26/2020, 5:16 PM

@william-p You've probably tried this but I'm going to suggest it anyway.

Have you imported your 2m 40s file into DVDAS using this option?

If you did, then did you make sure that the Menu Length is set to 'Auto calculate'?

I've done this and my music plays to the end. If you want the music to play again and keep playing until someone clicks a button you have to change the 'End Action/Command' from Hold to Loop.

This method works for me. It should work for you.

william-p wrote on 8/27/2020, 10:11 AM

You are definitely my hero!!! It worked. It was the "Auto Calculate" that I was missing. I hope you're watching when I have my next problem!

Jack S wrote on 8/27/2020, 10:50 AM

@william-p Thanks for getting back, and you're welcome.

Feel free to mark the comment as a solution so that the post is resolved.