Replacing a still

magicman wrote on 9/28/2002, 1:53 PM

I have an event with a still picture that has track pan and crop, and multiple FX. However, I want to use another picture. How can I replace the picture without recreating the entire event.

Comments

jetdv wrote on 9/28/2002, 2:18 PM

How about save a new picture with the same name in the same location as the old picture. When the project is re-opened, it should pick up the new picture instead. (You may want to back up the old picture first)

FadeToBlack wrote on 9/28/2002, 2:48 PM

magicman wrote on 9/28/2002, 5:34 PM

I'll "Take" your advice. Pun intended. Thanks

sonicboom wrote on 9/28/2002, 11:21 PM

GG---does this work for video too?
i would think so--i will check
and read the manual
thnx
sb

FadeToBlack wrote on 9/29/2002, 12:36 AM

sonicboom wrote on 9/29/2002, 11:11 AM

GG thnx
this is going to save many hours each project
because now i will make a "dummy" project preset and then simply add "take" video and stills in the project.....
thnx
sb