Tip: Making Presets . . . get rid of unwanted KeyFrames!

Grazie wrote on 1/10/2005, 10:52 PM

If you create a Preset and store it, make sure you remove your "development" key frames - otherwise those keyframes "not" at ZERO will keep on adjusting your piece as your Event progresses - HAH! I knew this, but it has just bit me in the Bottom AGAIN! - Oh same goes for Paste Event Attributes with those extra KFs, being "sprinkled" throughout your piece! Now gotta go back and Redo! Arrrghhhh...

Grazie

Comments

BillyBoy wrote on 1/11/2005, 5:49 AM

Been there, done that. Its always the little things that jump up and bite you in the butt. Thanks for sharing. Feeling better yet?

Grazie wrote on 1/11/2005, 6:33 AM

My Dear Boy! . . Better for you asking .. . finally seem to be "kicking-it" .. This has been a result of NOT wanting to take peni .. one bout before Christmas . . time I met Liam . .one bout after lasted till a day ago .. nasty ..

.. and yes . . THOSE K/Fs! . . . One lets them loose at ones own peril . .don't you know!

Grazie

Skywatcher wrote on 1/11/2005, 6:41 AM

I did that too. I set my cursor to sync with keyframing and that bites my hide every time!

Man...the little things! But, I am not alone eh??