I recently installed Vegas 6 to capture HD video from a JVC HD10. I am actually using the JVC CU-VH1 deck which gets recognized fine by Vegas 6. Everything captures fine if I start and stop the capture during a scene. However, if I let the capture run until the video reaches a point where the scene changes, the camera recording was turned off and then turned back on, then right at that point I get an error message about sending the fault report to microsoft and after I click on that, (either send or don't send the report) the entire Vegas program crashes and closes. Anybody have any experience with this crash.

I emailed Sony support, but have not heard back yet. This is an annoying bug.

Thanks for any suggestions.