Hi, I am somewhat new to Vegas Pro in some ways, transitioning from Adober Premier Pro. I have just started a new project which will produce my first 4K UHD Blu Ray disk. My source material is image sequences which are of higher resoution and lower aspect ratio than 4K. There are at least three ways I would like to display these clips. First, I might want to show the entire frame without cutting any off or stretching. This will result in black bars to the right and left of the image and of course, pixel interpolation. This is what I am getting by default. The second way is I might want to fill the 4K frame, which means some of the top and bottom of the image will be cut off. This of course will result in pixel interpolation. I should be able to raise and lower the image to select what part of the image sequence will be shown. Finally, I might want to display the image at a 1 to 1 pixel ratio, so that there is no pixel interplation. This would mean that some of the top, bottom and sides will be cut off. I should then be able to move the image right/left/up and down to select which part of the image will be shown. This is all very easy in Premier. In Premier I change the upper left window from clip preview to Effects. It then shows settings for the selected clip. Here, under motion, there is position and scale. If I want a 1:1 pixel ratio I set the scale at 100%. Or I can zoom in and out, and use position to move the image up and down. I can't find a similar setting in Vegas Pro. I am trying to work with Event Pan/Crop. But this doesn't seem to work. here I see the resolution of the original images. It looks like position will be easy to adjust here. But I don't see a zoom or scale control. Where do I make this adjustment and how do I know when the image is at a 1:1 pixel ratio ?