In 13, I would use CTRL-[ and CTRL-] to jump the cursor to the start and end of the current selection.
In 15, CTRL-[ still jumps to the start,
but CTRL-] also goes to the start, not the end.
Am I doing something wrong ?
How do you skip to the end of the current selection?
Confirmed, same with my MVP15.
Same here in my VMS 15. In my VMS 15 Platinum at least NumPad 9 skips to the end of the selected event and NumPad 7 to the start.
Wait, I just tested VMS13 and CTRl-] does not go to the end of the selection either
Was I just imagining this, and only ever used CTRL-[ to go the the start?
Numpad 7 = HOME
numpad 9 = PAGE UP
Page-UP just jumps to the next timeline section marker.It does not go to start/end of selection.
HOME goes to start of file, not selected event.
Do you have the Platinum version?
From online Help in Platinum:
"Enter edge-trimming mode and select event start; move to previous event edge - Numeric keypad 7
Enter edge-trimming mode and select event end; move to next event edge - Numeric Keypad 9 "
As I said earlier, these work for me only in Platinum. ("for a few extra dollars Platinum offers [much] more")
(The KB shortcuts including "[" or "]" do not seem to work for me anyway, due maybe to my non-US KB layout.)
Same here in my VMS 15. In my VMS 15 Platinum at least NumPad 9 skips to the end of the selected event and NumPad 7 to the start.
This is how my MSP16 works as well, with the numpad on. Pressing 9 will skip to the end of the selected event, pressing 9 again will select the next event, and pressing 9 again will then move to the end of this newly selected event.
No Platinum for me.